Filleting a Northern Pike (and all other fish)

STEP 1: Make first cut by grasping fish between the gills and poking knife into softer throat region ahead of the two front fins
Fillet a Northern Pike

STEP 2: Slide knife forward towards tail of fish between the two middle fins and stop by the bottom fin just in front of tail
2

(Still) STEP 2: Slide knife forward towards tail of fish between the two middle fins and stop by the bottom fin just in front of tail
3

 

STEP 3: Lay fish on side and make a vertical cut using a sawing motion down to the backbone taking care to NOT slice through the backbone.
4

 

STEP 4: Turn your knife flat and parallel to the backbone. Saw along the backbone (You’ll hear rib-bones and “Y” bones being cut through) to the tail, removing the complete slab of fish meat (?) which is one fillet. Do this to each side of fish.
5

STEP 4a: Cutting gets easier near the tail doe to no rib bones
6

 

STEP 5: Remove the belly fin by slicing with the tip of your knife.
7

STEP 5a: Removing fin is easy if you hold it up and slice it off
8

 

STEP 6: Locate the row of rib bones on the fillet by feeling them with your finger. Then, place your knife edge right behind them and slice underneath. Remember to turn your knife blade up against the underside of the ribs immediately as you are making long, steady slices down the row of rib bones. The idea here is to remove the ribs without wasting meat.
9

STEP 6a: After slicing about half to three quarters of the way under the ribs, hold the fillet down with your knife point, grasp the ribs and tear them out. This move greatly speeds up the process and helps if you have a lot of fish to fillet.
10

 

STEP 7: Grasp the tail of the fillet with pliers and cut into flesh with blade while turning blade almost flat and sawing. Simultaneously pull with the pliers and push with the knife with a sawing motion. It helps to waggle your plier hand from side to side as your knife hand saws down the skin of the fillet.
11

 

STEP 7a: Continue down the fillet. The feeling in the knife is one of slight tearing as it cuts. Too sharp of your blade angle and you slice through the hide. Too flat of a blade angle and you will leave meat on the hide. Your knife must be quite sharp and you’ll need to develop a feel.
12

 

STEP 7b: If you will be transporting your fillets, turn your blade down and slice sideways leaving a patch of skin on the fillet for identification purposes.
13

STEP 8: Completed Northern Pike fillets will look like this if done properly. If they look like they were driven over by a street sweeper, you’ll need a bit more practice.
14

One thought on “Filleting a Northern Pike (and all other fish)

  1. Pingback: How to Eat a Northern Pike | Northwind Lodge - Ely Minnesota

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s